Order By Sunday, December 17th to receive by Christmas!

Heaters, Stoves & Supplies 229 Results

View

Fahrenheat 240-volt Garage Heater 7500 Watt, 31.3 Amp

$467.99

  • Ideal for garages, workshops, basements or outside buildings
  • Rugged, heavy-duty industrial type heater
  • Built-in ceiling mount bracket for easyvertical or horizontal mounting
  • Built-in thermostat
  • 14".L x 12 1/2".W x 12 3/8".H

Mr. Heater Big Maxx Propane Unit Heater

$429.99

    • Forced Air Propane Unit Heater is efficient and effective convection heat for your garage or workshop or other residential or commerical use
    • 50,000 BTU per hour
    • Ships as a natural gas unit but comes with LP conversion kit
    • Heats up to 700 Sq. Ft.
    • Spark ignition has self-diagnostic control module
    • Low Profile Design means it can be installed in low-ceiling buildings
    • Minimum 8' clearance from floor to base of heater required
Includes:
    • 2 Angle brackets for ceiling mount

Pro-Temp Kerosene Heater - 220,000 BTU

$379.99

  • Available In Store Only - Pickup OK
  • Quiet forced air heating solution for spaces up to 5,500' sq
  • Utilizes the newest development in torpedo heater design
  • 50% quieter, 46% more energy efficient than equivalent forced air heaters
  • Require no routine maintence to keep them running smoothly
  • Come equipped with the most modern safety features available
  • 685 CFM air flow
  • 13 gallon fuel tank capacity
  • Consumes between 1.29 and 1.67 gallons per hour
  • 10 hours maximum operating time

Dewalt Forced Air Kerosene Construction Heater

$369.99

  • 185,000 BTU/HR
  • Equipped with a 25°F-95°F thermostat
  • The heating element cycles on and off to maintain the set temperature
  • 10" Flat free tires
  • Time saving assembly
  • Recessed controls designed to reduce the risk of having the knobs or valves damaged on the jobsite
  • Continuous electronic ignition is always present as a source of ignition for unburned fuel, reducing the ability for fuels to pool and collect in a dangerous manner
  • Heats up to 4,700 Sq. Ft.

Superpro 6" Class A Wall Support Kit

$359.99 $144.00

  • ShelterPro's Wall Support Kit is used when installing a chimney through the outside wall and up the side of the house on the outside
  • It includes a deluxe rain cap, adjustable wall support, wall bands, an insulated tee and plug, a wall thimble, a stove pipe adaptor and locking bands
  • The kit has all you need except the chimney

Superpro 6" Cathedral Ceiling Support Kit

$149.99 $60.00

  • ShelterPro's Cathedral Ceiling Support Kit is used when there is no attic space, but a cathedral ceiling
  • It includes a deluxe rain cap, a stove pipe adaptor and a cathedral ceiling support
  • That is all the components one needs except for the roof flashing and the chimney

Superpro 6" Deluxe Ceiling Support Kit

$169.99 $68.00

  •  ShelterPro's Deluxe Ceiling Kit is used when installing a chimney through a ceiling that has an attic
  • It includes a deluxe rain cap, attic insulation shield, a stove pipe adaptor, and a deluxe ceiling support
  • It has all the components one needs except the chimney and the roof flashing

HY-C Company 6" Superpro Storm Collar

$74.99 $30.00

  • Designed for use with SuperPro Chimney pipe
  • Use a storm collar on through-the-roof installations
  • Made of stainless steel and painted black
  • Manufacturers Limited Lifetime Warranty
  • Listings: safety tested and listed to applicalbe UL/ULC standards; USA: UL 103HT

Superpro 6" Stainless Steel Deluxe Chimney Cap

$69.99 $28.00

  • Advanced design, premium quality stainless steel.
  • Provides protection against the elements.
  • Twist Lock connection for secure and easy installation.
  • For use with 6" SuperPro Chimney Pipe

Selkirk Type L Elbow Vent 3 "

$54.99 $22.00

  • Vp Pellet Vent
  • Type L Vent Systems For Pellet Stove Applications
  • For Use On Approved Vp Standard For Residential Type And Building Heating Appliance Chimneys
  • Rated For Flu Temperatures Up To 570 Deg. F
  • 10 Year Warranty

Superpro 6" Inside Diameter 12" Long Stainless Steel Class A Double Wall

$74.99 $30.00

  • "Solid Pack" Insulation is augured for better insulating value (than blanket insulation) to keep outside temperatures low - for safety and inside temperatures high - for performance.
  • Premium Grade 304 alloy Stainless Steel Inner and Outer liner for enhanced draft and corrosion prevention
  • Premium Fiber Insulation made of 100% Mineral Wool with no Chlorides
  • Embossed Coupler: Prevents moister penetration
  • Twist Lock Connections for easy installation and assembly.
  • Limited Lifetime Warranty
  • Slim, advanced design allows for installation between 16" centers and still provides 2" clearance from combustible material.

HY-C Company 3" Pellet Vent Pipe Wall Bracket/Support

$59.99 $24.00

  • Selkirk Pellet Pipe Wall Bracket/Support is used to support vent pipe or tee sections
  • VP Pellet Pipe is used for venting pellet or corn burning stoves approved for use with PL-Vent
  • The appliance's flue gases must not exceed 570° F (298.80° C)

HY-C Company 3" Pellet Pipe Adjustable Flashing

$28.99 $11.60

  • For use as roof flashing
  • Use only with Selkirk pellet stove pipe
  • Keeps water and other debris from entering between the pipe and roof
  • Adjustable pitch

HY-C Company 3" 45 Degree Elbow

$44.99 $18.00

  • Used for a 45° offset and can be used in vertical and horizontal installations
  • Features proven gasketed coupling joints that connect in seconds to assure joint integrity
  • Constructed of 304 stainless steel inner wall and paintable galvanized outer wall
  • Internal spacing bead assures uniform insulating air space between pipe walls, and allows for 3" clearance to combustible materials
  • Male end is rolled over eliminating sharp edges

HY-C Company 3" Multi-Fit Chimney Connector

$34.99 $14.00

  • Used to transition Pellet Pipe to existing chimney
  • Can be used in vertical and horizontal installations
  • Features proven gasketed coupling joints that connect in seconds to assure joint integrity
  • Constructed of 304 stainless steel inner wall and paintable galvanized outer wall
  • Internal spacing bead assures uniform insulating air space between pipe walls, and allows for 3" clearance to combustible materials

Superpro 6" Inside Diameter 36" Long Stainless Steel Class A Double Wall

$94.99 $38.00

  • "Solid Pack" Insulation is augured for better insulating value (than blanket insulation) to keep outside temperatures low - for safety and inside temperatures high - for performance.
  • Premium Grade 304 alloy Stainless Steel Inner and Outer liner for enhanced draft and corrosion prevention
  • Premium Fiber Insulation made of 100% Mineral Wool with no Chlorides
  • Embossed Coupler: Prevents moister penetration
  • Twist Lock Connections for easy installation and assembly.
  • Limited Lifetime Warranty
  • Slim, advanced design allows for installation between 16" centers and still provides 2" clearance from combustible material.

HY-C Company 3" Pellet Vent Pipe Vertical Termination Cap

$31.99 $12.80

  • Selkirk Vertical Termination Cap is used for vertical installations only
  • It is required where pipe terminates above the roofline
  • Used for venting pellet or corn burning stoves approved for use with PL-Vent
  • The appliance's flue gases must not exceed 570° F (298.80° C)

Superpro 6" Painted Stainless Steel Stovepipe To Chimney Adaptor

$49.99 $20.00

  • Diameter: 6"
  • Fabricated with stainless steel with black paint finish

Superpro 6" Flat to 6/12 Pitch Galvalume Adjustable Flashing Assembly with Storm Collar

$59.99 $24.00

  • Designed for 6'' SuperPro chimney pipe
  • Gavalume coating for twice the corrosion resistance of galvanized steel
  • Used where the chimney passes through a roof with a pitch of Flat to 6/12

Superpro 6" Stainless Steel Wall Band

$25.99 $10.40

  • Supports and stabilizes chimney pipe
  • Corrosion-resistant stainless steel construction

HY-C Company 3" Pellet Horizontal Termination

$54.99 $22.00

  • 3" horizontal termination cap
  • Type L insulated pipe for pellet stove applications

Mr. Heater Contractor 75,000 BTU Forced-Air Kerosene Heater

$224.99

  • 75,000 BTU for up to 1,750 square feet
  • 6-Gallon fuel tank provides up to 11 hours of heat; adjustable thermostat
  • High-output fan; no-flame and over-heat safety sensors with auto shut-off
  • Power indicator light; fuel gauge; easy-off gas cap; cord storage; carrying handle

DuraHeat Propane Cabinet Work Space Heater

$129.99

  • Uses standard 20 lb. cylinder
  • Provides up to 18,000 Btu's
  • Adjustable heat control
  • Built-in wind shield
  • ODS safety shut-off
  • Includes:
    • Hose and regulator

Dewalt 150,000 BTU/HR Forced Air Propane Heater

$239.99

  • Patented Quiet Burner Technology reduces the combustion and operation noise by up to 50%
  • Rugged two-piece split barrel, designed to make cleaning and maintenance easier and safer
  • Recessed controls designed to reduce the risk of damage on the jobsite
  • Continuous electronic ignition is always present as a source of ignition for unburned fuel, reducing the ability for fuels to pool and collect in a dangerous manner.
View